Metal Roofing Techniques

Then cover the entire roof with a layer of insulation and secure it with a staple gun.

Metal roofing techniques.

The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof. There are so many tips and tricks to metal roofing. To save you a lot of time and energy you will also want to mark your blade. Metal roofing is also available in the form of shingles.

Admin february 10 2020. These tools are obvious. Proper execution of the correct installation techniques helps preserve roof structure and longevity. There are too many old souls in this industry who have forgotten more than us newbies will ever know.

Begin installation at the bottom of the roof along the eaves and steadily work your way upwards. Place the panels in one row across the roof. The first row of metal panels should overhang the roof by about 6 inches to prevent water infiltration. The key here is to steal your info.

So in saying this just pay attention a minute. You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened. Measuring tape sharpies pencils and a blade. Next you are ready to install the metal roof.

You re going to be doing a lot of marking a lot of scoring of the metal and we recommend having a folding locking knife in your belt at all times. Exposed fastened metal roof panel installation. These clips will typically allow for panel expansion and contraction without damage. Anatomy of a metal roof a metal roof is made of panels supported by the purlins that make up the secondary frame structure.

Metal roofing tips and tricks. Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails. For single skin roofing there are three fastening system options. You can use 1 inch nails for the installation of eave flashing.

Overlap each subsequent row by 2 to 4 inches for a watertight seal. Before you install metal roofing repair any damage to the wood under the shingles. Next use 1 inch nails to secure some metal edging to the perimeter of the roof. Installation techniques vary greatly depending on the metal roof s fastening system.